Product Details
Introduction
This kind of roof panel roll forming machine mainly produce steel roof/ wall sheet. As we know, steel roof/ wall sheet is widely used in large span factory building, warehouse, office buildings, villas, roof, cold storage, air purification room, stores, kiosks, and temporary housing.
1. Machine Specifications
1 |
Coil Type |
Pre-painted coil, Galvanized steel or G500 G550 |
2 |
Width |
1220mm or as per client's request |
3 |
Thickness Range |
0.2-1mm |
4 |
Effective width |
1050mm or as per drawing |
|
1 |
Power Requirement |
Voltage |
(380V 50HZ), or according client require |
Main Motor power |
5.5kw as per sheet thickness |
Cutter power |
5.5kw as per sheet thickness |
2 |
Forming speed |
10-15m/min |
|
3 |
Forming stations |
13 rows, as per finial machine |
4 |
Main Frame |
300H beam |
5 |
Sidewall thickness |
14mm |
6 |
Forming shaft diameter |
70mm 0.01mm-0.03mm (Grinding) |
7 |
Chain |
1inch chain drive or as per design |
8 |
Type of cutting |
Roll formed and length-set cutting |
9 |
Control system |
PLC control |
10 |
Install dimension (depend on the final design) |
7.4m 1.5m 1.3m |
11 |
Total weight (Approx) |
3.5T |
12 |
Roller material |
High grade 45# steel, hard chrome plated |
13 |
Feeding system |
Guide type |
14 |
Cutting blade |
Cr12 |
15 |
Frequency changer |
Delta |
Manual Decoiler |
Usage: It is used to support the steel coil and uncoil it in a turnable way. The steel coil is uncoiled automatically.
Loading capacity: 5T
Inner diameter: 450-508mm |
Guiding Device |
Adopt guiding bar and sliding block to control the width and position of the steel sheet.
Pre-cutter used to cut sheet before roll forming, saving material. |
Roll Forming System |
Material of rollers: High grade 45# steel, roller surfaces polishing, hard plating chrome coated 0.05mm The polished surface and the heat treatment towards the molds also can keep the molding plate surface smooth and not easy to be marked when it is being stamped.
The 5mm thick sleeve instead of galvanized pipe. To make the shaft and rollers more stable in order to make the profile |
Cutting device |
A. Adopts post cutting, the cutting blade material is Cr12 with quenched treatment, after cutting, there is no material wasted.
B. Adopts welded frame for good rigidity.
C. The cutting action is drove by the power from hydraulic station which guarantees the procession of the cutting and low |
Hydraulic System |
It is controlled by gear wheel oil pump. After filling the hydraulic oil into the hydraulic oil tank, the pump drive the cutter machine to begin the cutting job. |
PLC Control System |
The target piece`s length is adjustable and digit of it can be adjusted. Computed mode has two modes: automatic and manual one. The system is easy to operate and use
PLC: Delta |
Run out table |
To receive the finished products. |
2. Process Drawing
http://www.jrrollformingmachine.com/
Company Profile
